A frayed or snapped lift cable throws the whole door off balance, and a door hanging crooked on one cable is a genuine safety hazard. We replace cables and inspect the drums they wind onto.
Matching wear on both cables means both get inspected and typically replaced together.
Cable replacement without a drum check is an incomplete repair, so we always look at both.
Our technicians are trained to safely release and reset tension when cables are involved, not just the springs.
Cable stock in standard gauges means most replacements happen in a single visit.
Whatever brought you here, one of these service lines is the fix, and one call gets a technician moving.
We replace the snapped cable and its pair, then verify even tension across both sides.
Fraying cable strands are a warning sign of imminent failure. We replace before it snaps and drops the door unexpectedly.
If the cable keeps slipping off the drum, we look for a bent drum or misaligned track causing the repeat issue.
We match new drums to the correct diameter for your door's cable length requirements.
A door hanging crooked usually means one cable or spring has failed while the other holds. We correct both the immediate hazard and the root cause.
Tell us if the door is hanging crooked or jammed, that detail helps us prioritize the call correctly.
Technicians carry standard cable gauges and lengths for most residential doors.
We check both cables and the drums together, then quote a flat price covering the full fix.
Cables replaced, tension balanced, and the door tested level before we leave, backed by written warranty.
“Door was hanging at an angle after a cable snapped. They replaced both cables and it's perfectly level now.”
“Explained why replacing just one cable wasn't a real fix. Makes sense once you see the wear pattern.”
“Same-day fix on a Saturday, cable stock right there on the truck.”
An uneven hang points to a broken cable, a failed spring, or a bent track pulling the panel off-square.
We recommend replacing both since they wear on the same cycle, and we'll explain the reasoning before you decide.
This is a genuine safety hazard, especially with people or vehicles near the door opening.
Usually a bent or worn drum groove, sometimes combined with a slightly loose cable tension setting.
Pricing depends on cable length, gauge, and whether the drums also need replacing, confirmed as a flat number before work starts.
A snapped-cable call usually resolves in under two hours on-site.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591Technicians are positioned throughout Palmer for fast response, and we cover the surrounding zip codes too.
Embedded Map Placeholder for Palmer, AK